3U VPX 10 Gigabit Ethernet Switch with Optional Layer 2 Switching and Layer 3 Routing Management Support
The XChange3018 from Extreme Engineering is a 3U, conduction- or air-cooled, VPX 10 Gigabit Ethernet switch module, providing four 10 Gigabit Ethernet 10GBASE-T or XAUI ports, six backplane 10/100/1000BASE-T Ethernet ports, and six backplane network 1000BASE-X Ethernet ports.
Technical
Non-blocking, full wire-speed, Ethernet switch
Optional Layer 2 switching and Layer 3 routing management with extensive IEEE protocol and IETF RFC support
Four 10GBASE-T or XAUI 10 Gigabit Ethernet ports
Six 10/100/1000BASE-T Gigabit Ethernet ports
Six 1000BASE-X SerDes Gigabit Ethernet ports
Supports the XPedite5205 Cisco™ IOS® Embedded Services Router
Ruggedised Enhanced Design Implementation (REDI) per VITA 48
Conduction or air cooling
IPv4 and IPv6 support
Support for Jumbo Frames up to 13 KB
Optional IEEE 1588v2 and SyncE support
Optional NTP, SSH, SNMP, and DHCP server support
Freescale QorIQ™ P1010 Management Processor
Optional IPMI support
Specifications
Ethernet
Four 10GBASE-T or XAUI 10 Gigabit Ethernet interfaces
Six 10/100/1000BASE-T Ethernet interfaces
Six 1000BASE-X SerDes Gigabit Ethernet interfaces
IPv4 and IPv6 support
Support for jumbo frames up to 12 kB
Advanced cable open/short detection
Energy Efficient Ethernet™ support
Non-blocking, full wire-speed
IEEE 1588v2 and SyncE support (optional)
Optional Ethernet Management Features
Layer 2 switching and Layer 3 routing
Extensive IEEE protocol and IETF RFC support
Configuration through CLI or SNMP
196 MB packet buffer
VICTORY Infrastructure Switch and Router support
Management Controller
Freescale QorIQ P1010 Management Processor at up to 800 MHz
Up to 2 GB DDR3L-800 ECC SDRAM
Up to 8 GB NAND flash
Dual-redundant SPI boot flash
NTP, SSH, SNMP, and DHCP server support (optional)
There are a number of different options available. Please contact Sarsen Technology for appropriate board configurations based on environmental requirements
LOG IN /
